7823
* 16-bit ISA interface.
* Supports (1) Type II and (1) Type III or (2) Type II PC Cards.
PC FLASH CARDS
Manufacturer: AMD
Distributor: MPEC Corporation
17890 Castleton Street, Suite 104
City of Industry, CA 91748
Phone (626) 913-7200
Fax (626) 913-7550
Model: PCMCIA Type I
Part Number: MPE-FAD004-P
Description: PC Card 4MB Flash Memory Card. AMD D-Series Flash 5V
Retail Price: $89.00 + Shipping and handling
TAUS0608643EN00
Solution ID
10
Solution Usage
Description
Fuser oil has run out message displayed and the Fuser Oil Refill button is grayed out. The fuser oil was refilled.
Solution
When the message FUSER OIL HAS RUN OUT is displayed the machine will stop coping. A warning message that the fuser oil was low was displayed for
200 copies before the machine is stopped. The ability to reset the fuser oil message can done by the user or the service technician. Touch the Utility Button, if
the Fuser Oil Refill button is grayed out the machine is set for service to reset.
To change from service set to user set perform the following:
1. Press the [Utility] key then press Meter Count.
2. Press [Stop], [0], [0], [Stop], [0], [1] to enter service mode.
3. Press Settings.
4. Press Fuser Oil Change.
5. Press User Set to change to user mode.
6. Pres Ex. repeatedly to exit service mode.
The user can now manage fuser oil replenishment.
TAUS0607906EN00
Solution ID
9
Solution Usage
Description
Standard memory configuration for the Fiery* controllers.
Solution
X2E - 64MB (standard), 160MB upgrade (option - PCUA 950603)
X2 - 160MB
ZX-2100 - 160MB
ZX-3300 - 256MB
Note: The 160MB upgrade option for the X2E consists of a software update and a 128MB DIMM. One of the existing 32MB DIMMs is removed and then
replaced with the 128MB DIMM.
* Trademark ownership information
TAUS0608028EN00
Solution ID
9
Solution Usage
Description
Code C3310 at power up.
Solution
CAUSE: CCD connectors are not secured to the I/R control board when the editor control board or the embedded print controller are installed.
SOLUTION: Reseat the connectors for the CCD. The Trouble Reset Switch must be pressed to reset the malfunction code. This switch is located on the
underside of the operation panel. An access cover is available inside the front door.
TAUS0608500EN00
Solution ID
9
Solution Usage
Description
Copies or prints have a very high image density.
5
Copyright 2006, Konica Minolta Business Solutions U.S.A., Inc.
October 2006
(152 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales