7823
Fiery* ZX, are the Konica print drivers currently supported in a Microsoft* Windows 2000 environment?
Solution
Windows 2000 print drivers for the Z4, ZX and X2/X2e controllers are now available from the Konica FTP site [[(Internal Link for Faxing/Printing FTP site
information)| RUN V:\text\Wordpad.exe v:\text\CBC009.txt]] FTP_ user site.txt file [[(Internal Link for Faxing/Printing FTP_ user site.txt file information)| RUN
V:\text\Wordpad.exe v:\text\CBC010.txt]]
* Trademark ownership information
TAUS0610494EN00
Solution ID
0
Solution Usage
Description
On Windows* 9x clients, a new printer created on a Windows NT Server cannot be seen in Network Neighborhood.
Solution
CAUSE: The newly-created printer has a share name greater than 12 characters long.
SOLUTION: Windows 9x has a limitation of not being able to see share names that exceed 12 characters in length. Ensure that any shares do not exceed
12 characters.
Note: Windows NT workstations do not have this limitation.
* Trademark ownership information
TAUS0612116EN00
Solution ID
0
Solution Usage
Description
Power requirements, 7823
Solution
Voltage: 115V AC ñ 10%, dedicated line recommended
Current: 15A
Frequency: 60 Hz ñ 2.5Hz
Grounding: Isolation recommended
Termination: NEMA Type 5-15R receptacle (125V AC, 2-pole, 3-wire, grounded).
Note: A dedicated AC line with an isolated ground is strongly recommended. A dedicated line mandates the exclusive use of an electrical branch circuit
where the receptacle grounding terminal is grounded by an insulated grounding conductor that is isolated from the receptacle mounting hardware (per
National Electrical code, article 250-74, exception no. 4).
TAUS0613122EN00
Solution ID
0
Solution Usage
Description
C3F90 displayed during warm-up.
Solution
CAUSE: The PC drum is not properly installed.
SOLUTION: Ensure that the PC drum is inserted fully into the machine. It may be necessary to rotate the drum slightly clockwise until it fully slides into place.
To reset the C3F90 error message, perform the following:
1. Move the Transfer Unit handle (M4) to the right to lock it into place.
2. Remove the cover over the Tech. Rep Setting Switches Board.
3. Press switch S24 to reset the message.
4. Replace the plastic cover over the Tech. Rep Setting Switches Board.
TAUS0613157EN00
Solution ID
0
Solution Usage
Description
Error message occurs when trying to configure the Fiery Color Calibrator software, "This application requires color server system version 6.0 or greater".
Solution
CAUSE: Incorrect information was entered in either the Server Name or Device fields.
47
Copyright 2006, Konica Minolta Business Solutions U.S.A., Inc.
October 2006
(152 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales