7823
5. Select the desired cassette and choose the desired paper size for the cassette.
6. Press Ex. repeatedly to exit service mode.
TAUS0614144EN00
Solution ID
1
Solution Usage
Description
Code C0F30 after or during copying.
Solution
CAUSE: The black toner transport motor (M22) has failed or the toner is clogged in the transport.
SOLUTION: Clean the toner transport system. Replace M22 (p/n 25TU80130) if the problem still occurs.
TAUS0614444EN00
Solution ID
1
Solution Usage
Description
Fiery* X2e, cannot print from a Microsoft* Windows 2000 server. The job leaves the queue, but does not print out at the Fiery. The server can ping the Fiery.
Solution
CAUSE: LPR printing is utilized and LPR Byte Counting is not enabled on the printer port.
SOLUTION: When setting up LPR printing , ensure that LPR Byte Counting is selected. To enable LPR Byte Counting, perform the following:
1. Right click the on the network printer and select PROPERTIES.
2. Select the PORTS tab.
3. Select CONFIGURE PORT.
4. Check the box for LPR Byte Counting Enabled and click OK.
Notes:
a. When LPR Byte Counting is enabled, the computer counts the number of bytes in a document before sending it to the printer. Byte counting which can
be very time consuming is not required by most printers however some documents may require this selection. This option is available only with the LPR
option.
b. To view the PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
TAUS0614558EN00
Solution ID
1
Solution Usage
Description
Fiery* X2, part number for the system software.
Solution
The part number for the Fiery X2 system software is 45004874.
* Trademark ownership information
TAUS0614625EN00
Solution ID
1
Solution Usage
Description
Light copies after set up of a new machine.
Solution
CAUSE: The holding plate (shipping bracket) from the transfer corona unit was not removed.
SOLUTION: Remove the holding plate. Refer to the second page of the Unpacking/Setting-Up Instructions.
TAUS0614639EN00
Solution ID
1
Solution Usage
Description
OUT OF PAPER message for the lower tray. The tray will not lift until the left side door is opened and then shut.
35
Copyright 2006, Konica Minolta Business Solutions U.S.A., Inc.
October 2006
(152 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales