Di200
TAUS0633676EN00
Solution ID
0
Solution Usage
Description
AFR17, originals of an irregular size are cut off when run through the feeder.
Solution
CAUSE: The IR erasure width setting is too high, causing the machine to erase part of the original image.
SOLUTION: Set the IR erasure width setting to 0mm. This is accomplished by entering the tech rep mode and selecting tech rep choice. Select IR erasure
width, clear the value using the clear key of the control panel and enter 0. Press enter to lock in the setting.
Refer to Bulletin 3352 for additional information.
Note: To view the above PDF, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for free from the Adobe* Web site at:
[[http://www.adobe.com/products/acrobat/readstep2.html| URL
http://www.adobe.com/products/acrobat/readstep2.html]]
* Trademark ownership information
TAUS0633814EN00
Solution ID
0
Solution Usage
Description
PROBLEM: While using the AF-9 document feeder the copies exit the machine skewed.
Solution
CAUSE: Due to a difference in pressure of the turnover rollers, some types of paper will skew when being taken up.
SOLUTION: A new turnover roller has been made available to prevent skewing from occuring. Please see bulletin 3568 for further information.
TAUS0633843EN00
Solution ID
0
Solution Usage
Description
C-13F0 codes are repeatedly displayed.
Solution
PROBABLE CAUSES:
1. Poor connection. Verify that the ribbon cable from the print head to PWB-A is secure in its connector at PJ8 on PWB-A.
2. Incorrect settings. Verify that the FD and CD adjustments of the printer are not set too high, as the SOS sensor will not be able to sense the scan start
position.
3. Incorrect operation of the print head. Verify that the polygon motor is starting (you should hear a high pitch) and replace the printhead, if nedcessary.
4. Failure of PWB-A. Replace the board.
TAUS0633859EN00
Solution ID
0
Solution Usage
Description
The option for Network settings does not appear on copier interface panel.
Solution
CAUSE: Updated firmware and system software is required.
SOLUTION: Please make sure the latest firmware on the copier and system software are installed.
TAUS0634013EN00
Solution ID
0
Solution Usage
Description
Requirements for criss-cross sorting.
Solution
Criss cross sorting is possible only when all the following conditions are met:
- The machine is loaded with paper of the same size and type in two different directions.
- Mixed Original Detection is set to off.
6
Copyright 2006, Konica Minolta Business Solutions U.S.A., Inc.
October 2006
(55 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales