Electronics For Imaging Fiery EX2101 Guía de instalación descargar pdf (Pagina 123)

6-5 Imposition settings

Creep Adjustment

Choose either Plain or Thick from the Creep Adjustment menu, or enter a value

(between 0 and 2 inches, or the equivalent in another measurement unit) to specify the

thickness of the sheet. When saddle-stitched binding is speciﬁed, DocBuilder Pro uses

this value to compensate automatically for binder’s creep (see “Shingling and creep” on

page A-8).

NOTE: Even if you choose Thick from the Creep Adjustment menu, your job prints on

Plain paper, unless you speciﬁed Thick paper in the job properties. For more

information on changing job properties from Command WorkStation, see “Viewing

and overriding print settings” on page 3-14.

Orientation

Use the Orientation menu to specify the orientation of a sheet. As an alternative to

rotating the sheet, you can perform custom rotations on any page in the main window,

as described in “Rotating pages” on page 6-22.

Duplex

Use the Duplex menu to specify the relationship of content areas on opposing sides of

a sheet. Specify On for duplex (two-sided) printing or Off for simplex (one-sided)

printing.

When you choose On, the job is printed as duplex using a Top-Top setting, meaning

that the tops of pages on opposing sides of a sheet are located on the same edge (usually

the preferred choice for imposed book layouts).

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 213 214

Sin comentarios

Electronics For Imaging Fiery EX2101 Guía de instalación Pagina 123