Electronics For Imaging Fiery X12 Información técnica descargar pdf (Pagina 173)

Click Print or OK (whichever is supported by your Fiery Server) to print the swatch page.

Print a color swatch book

When you print a swatch book, you select a spot color group and a layout.

In the Spot Colors window, select a color group and do one of the following:

• To print a swatch book of all of the spot colors in a color group, select the group and click Print.

• To print a swatch book of selected colors in a color group, select the group in the Spot Colors window,

Control-click to select the spot colors, and then click Print.

Select a layout.

• Color Swatches 8X4 prints patches in a 4-column by 8-row format.

• Color Swatches 8X8 prints patches in an 8-column by 8-row format.

If you did not already specify the Paper Source in the print settings (Properties), select a paper size and a paper

source for printing.

Click Print or OK (whichever is supported by your Fiery Server) to print the swatch page.

Measure and import spot color values

If you have a measurement instrument (such as the EFI ES-2000 spectrophotometer) that can measure a single color

sample, you can import a measured color value directly into a spot color definition. This feature allows you to match

spot colors based on the actual colors of physical objects, such as the red of a printed logo or the yellow of a

packaging envelope.

Before you begin

Note: To use an X-Rite i1Pro or i1Pro 2, you must use an instrument obtained from EFI. An instrument obtained

from another source will not work with Spot Colors.

Install and set up the spectrophotometer for use with your computer.

For installation and setup instructions, see the documentation that accompanies the instrument.

In Device Center, click the Resources tab and click Spot Colors.

Make sure that the instrument is connected and click Instrument.

Place the spectrophotometer in its calibration cradle and click Calibrate. Calibration improves the accuracy of

measurements.

Select the desired color group and click New > Spot Color, or double-click the spot color to edit.

Place the spectrophotometer over the target color, making sure to center the sample aperture over the color.

Fiery Command WorkStation

Managing color

173

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 256 257

Sin comentarios

Electronics For Imaging Fiery X12 Información técnica Pagina 173